TM 5-2330-325-13&P
0055
INSPECTION
NOTE
If torque rod eyes or spigot caps show visible cracks, they must be discarded and
replaced. If spigots show visible cracks, inform your Supervisor.
Oversize replacement bushings are available.
The standard bushing should be used until the spigot diameter is below 2.530 in.
(6.426 cm). To determine wear, take two measurements 90 degrees apart
(i.e., "A-A" and "B-B") as shown in Figure 2, or measure over visible wear area.
The smaller of the two dimensions is to be taken as the wear limit (see Table 1 for
values). If spigot is below the minimum dimension shown in Table 1, inform
your Supervisor.
Inspect torque rod eyes (Figure 1, Item 6), spigots (Figure 1, Item 4), and spigot caps (Figure 1, Item 1) for
visible cracks and wear.
Table 1.
Spigot Wear Limits.
PART NO.
SPIGOT
STD. BUSHING WEAR LIMIT
WEAR LIMIT FOR OVERSIZE
BUSHING
800021
Spigot #2
2.530 in. (6.426 cm) Min.
2.530 in. (6.426 cm) Max.
(800010 Bushing)
2.500 in. (6.35 cm) Min.
(800009* Bushing)
*Oversized Service Bushing
A
B
B
A
466-0054
Figure 2.
Joint Assembly.
END OF TASK
