TM 9-2320-363-34-2
2.
3.
4.
PLACE SERVICE SET HOLDING FIXTURE (3) IN VISE AND REMOVE ACCESSORY DRIVE PULLEY
LOCK NUT (4). DISCARD LOCK NUT.
REMOVE ACCESSORY DRIVE PULLEY (5) BY TAPPING WITH RUBBER HAMMER OR FIBER
MALLET. REMOVE SERVICE SET HOLDING FIXTURE (3) FROM VISE.
POSITION ACCESSORY DRIVE ASSEMBLY (1) ON PRESS BED WITH SERVICE SET HOLDING
FIXTURE (3) SUPPORTED. USING HYDRAULIC PRESS, APPLY PRESSURE THRU HOLDING
FIXTURE ACCESS HOLE (6) AND PRESS ACCESSORY DRIVE ASSEMBLY (1) OUT OF
ACCESSORY DRIVE GEAR (7). REMOVE THREE SCREWS (2) AND ACCESSORY DRIVE GEAR
(7).
12-107
