TM 9-2320-363-34-2
NOTE
Word INSTALL and an arrow are etched on needle bearing remover/installer to
aid in installation. Be sure to place needle bearing identification numbers up
against needle bearing remover/installer.
7.
TURN ACCESSORY DRIVE ASSEMBLY (1) OVER AND SUPPORT ON ATTACHING BOLT BOSSES.
PLACE LONG END OF SERVICE SET NEEDLE BEARING REMOVER/lNSTALLER (10) IN
ACCESSORY DRIVE ASSEMBLY (1) AGAINST NEEDLE BEARING (11). APPLY PRESSURE TO
NEEDLE BEARING REMOVER/INSTALLER (10) AND REMOVE AND DISCARD NEEDLE BEARING
(11) AND OIL SEAL (12).
8.
REMOVE SNAP RING (13) FROM ACCESSORY DRIVE SHAFT AND BEARING ASSEMBLY (9).
12-109