TM 9-2320-363-34-2
1.
PLACE NEW BALL BEARING ASSEMBLY (1) ON ACCESSORY DRIVE SHAFT (2). PLACE SMALL
OPENING OF SERVICE SET BEARING INSTALLER (3) OVER BALL BEARING ASSEMBLY (1)
INNER RACE. PRESS UNTIL BALL BEARING ASSEMBLY (1) BOTTOMS AGAINST SHOULDER OF
ACCESSORY DRIVE SHAFT (2).
NOTE
Make sure tapered side of snap ring is installed away from bearing.
Make sure snap ring is fully seated in groove of accessory drive shaft.
2.
INSTALL SNAP RING (4) IN GROOVE OF ACCESSORY DRIVE SHAFT (2).
12-111
