TM 9-2320-363-34-2
NOTE
Piston assembly components should be segregated by
matchmarked during disassembly to ensure installation in same
cylinder and
positions.
Holding fixture plate can be raised or lowered by turning. Adjust height of
plate so recess in piston pin ends alines with holding points of holding fixture.
9.
PLACE CONNECTING ROD AND PISTON ASSEMBLY (9) DOME SIDE DOWN ON HOLDING
FIXTURE PLATE (11) WITH PISTON PIN BETWEEN STATIONARY AND MOVABLE HOLDING
POINTS OF HOLDING FIXTURE (11). CONNECTING ROD SHOULD BE POSITIONED BETWEEN
HOLDING FINGER (12) OF HOLDING FIXTURE (11). SECURE CONNECTING ROD AND PISTON
ASSEMBLY (9) IN HOLDING FIXTURE (11) BY SLIDING MOVABLE PORTION OF HOLDING
FIXTURE (11) UNTIL IT CONTACTS PISTON PIN AND TIGHTENING HANDLE.
10. REMOVE TWO PISTON PIN BOLTS (13) AND TWO SPACERS (14).
11. REMOVE CONNECTING ROD ASSEMBLY (15).
12-145
