TM 9-2320-363-34-2
4.
5.
INSTALL NEW OIL SEAL (8) IN ACCESSORY DRIVE ASSEMBLY HOUSING (6). USING SERVICE
SET SEAL INSTALLER (9) AND PLASTIC HAMMER OR FIBER MALLET, INSTALL OIL SEAL (8)
FLUSH TO 0.01 IN. (0.25 mm) BELOW FACE OF ACCESSORY DRIVE ASSEMBLY HOUSING (6).
SUPPORT SERVICE SET HOLDING FIXTURE (10) ON TWO STEEL PLATES AND PLACE
ACCESSORY DRIVE ASSEMBLY HOUSING (6) IN SERVICE SET HOLDING FIXTURE (10) HOLE.
LUBRICATE BALL BEARING ASSEMBLY (1) WITH CLEAN ENGINE LUBRICATING OIL AND
INSTALL ACCESSORY DRIVE SHAFT (2) AND BALL BEARING ASSEMBLY (1) IN ACCESSORY
DRIVE ASSEMBLY HOUSING (6).
6.
USING WIDE END OF SERVICE SET BEARING INSTALLER (3), PRESS ON BALL BEARING
ASSEMBLY (1) OUTER RACE UNTIL BALL BEARING ASSEMBLY (1) IS SEATED AGAINST
SHOULDER OF ACCESSORY DRIVE ASSEMBLY HOUSING (6).
12-113
