TM 9-2320-363-34-2
9.
Support opposite end of accessory
on shaft.
NOTE
drive shaft on press bed when pressing gear
PLACE ACCESSORY DRIVE GEAR (13) ON ACCESSORY DRIVE SHAFT (2) WITH CHAMFERED
END OF BORE TOWARD ACCESSORY DRIVE SHAFT (2). USING PRESS, INSTALL ACCESSORY
DRIVE GEAR (13) UNTIL ACCESSORY DRIVE GEAR (13) IS FLUSH WITH END OF ACCESSORY
DRIVE SHAFT (2). OBTAIN MINIMUM PRESS LOAD OF 4,000 LB (17.8 kN).
10.
INSTALL SERVICE
ACCESSORY DRIVE
SET HOLDING FIXTURE (10) AND THREE FIXTURE SCREWS (14) ON
GEAR (13).
12-115