TM 9-2320-302-34
0039 00-10
ACCESSORY DRIVE REPAIR - CONTINUED
0039 00
ASSEMBLY - CONTINUED
NOTE
If necessary, use narrow opening end of service kit bearing installer to seat accessory drive pulley. If press-
ing is necessary, support opposite gear end of accessory drive shaft.
12.
Install accessory drive pulley (5) on accessory drive shaft (9).
13.
Install new accessory drive pulley lock nut (4) and tighten to 162-184 lb-ft (220-250 Nm).
14.
Remove service kit holding fixture (3) from vise and remove three fixture screws (2) from accessory drive gear (7).
4
5
3
9
2
3
7
