TM 9-2320-302-34
0039 00-8
ACCESSORY DRIVE REPAIR - CONTINUED
0039 00
ASSEMBLY - CONTINUED
6.
Using wide end of service kit bearing installer (16), press on ball bearing assembly (15) outer race until ball bearing
assembly is seated against shoulder of accessory drive assembly housing (1).
NOTE
•
Ensure tapered side of snap ring is installed away from bearing.
•
Ensure snap ring is fully seated in groove of accessory drive assembly.
7.
Install snap ring (8) in groove of accessory drive assembly (1).
8.
Apply thin film of lubriplate to drive gear end of accessory drive shaft (9).
16
15
1
1
8
9
