TM 9-2320-302-34
0039 00-7
ACCESSORY DRIVE REPAIR - CONTINUED
0039 00
ASSEMBLY - CONTINUED
4.
Install new oil seal (12) in accessory drive assembly housing (1). Using service kit seal installer (17) and plastic hammer
or fiber mallet, install oil seal flush to 0.01 in (0.25 mm) below face of accessory drive assembly housing.
5.
Support service kit holding fixture (3) on two steel plates (14) and place accessory drive assembly housing (1) in service
kit holding fixture hole. Lubricate ball bearing assembly (15) with clean engine lubricating oil and install accessory
drive shaft and bearing assembly (9) in accessory drive assembly housing.
17
12
1
15
9
1
3
14
