TM 9-2320-302-34
0039 00-4
ACCESSORY DRIVE REPAIR - CONTINUED
0039 00
DISASSEMBLY - CONTINUED
NOTE
Word INSTALL and an arrow are etched on needle bearing remover/installer to aid in installation. Place
needle bearing identification numbers up against needle bearing remover/installer.
7.
Turn accessory drive assembly (1) over and support on attaching bolt bosses. Place long end of service kit needle bear-
ing remover/installer (10) in accessory drive assembly against needle bearing (11). Apply pressure to needle bearing
remover/installer and remove and discard needle bearing and oil seal (12).
8.
Remove snap ring (13) from accessory drive shaft and bearing assembly (9).
9.
Place two steel press plates (14) under ball bearing assembly (15) outer race. Apply pressure to top of accessory drive
shaft and bearing assembly (9) and remove and discard ball bearing assembly.
11
12
1
10
13
9
