TM 9-2320-302-34
0018 00-5
CYLINDER HEAD REPLACEMENT - CONTINUED
0018 00
INSTALLATION - CONTINUED
3.
Install air compressor fitting (26) in cylinder head (3).
4.
Remove tags and install two elbows (24 and 25) in cylinder head (3).
5.
Install lifter (17) between fuel injectors no. 3 and no. 4.
a.
Install bolt (18) using bolt hole for center cam cap bolt.
b.
Install two bolts (19) using two tapped holes for engine retarder assembly.
WARNING
Cylinder head weighs 421 lb (191 kg). Use suitable lifting device to lift and support cylinder head. Failure to
do so could result in injury to personnel.
6.
Attach suitable lifting device to lifter eye (20) and position cylinder head (3) over engine block (27).
7.
Seat cylinder head (3) on diamond dowel (28) and round dowel (29) until full contact is made with cylinder head gasket
(21).
8.
Remove lifting device from lifter eye (20).
NOTE
If cylinder head is other than one removed, or if resurfaced cylinder head is being installed, three nuts retain-
ing adjustable idler gear must be loosened before installing and tightening camshaft drive gear retaining
bolt. Notify General Support Maintenance to perform adjustment.
9.
Remove lifter (17).
