TM 9-2320-302-34
0018 00-4
CYLINDER HEAD REPLACEMENT - CONTINUED
0018 00
REMOVAL - CONTINUED
WARNING
Cylinder head weighs 421 lb (191 kg). Use suitable lifting device to lift and support cylinder head. Failure to
do so could result in injury to personnel.
8.
Attach suitable lifting device to lifter eye (20) and remove cylinder head (3).
9.
Remove and discard cylinder head gasket (21).
10.
Remove bolt (22) and left rear lifting bracket (23).
11.
Tag and remove elbows (24 and 25) from cylinder head (3).
12.
Remove air compressor fitting (26) from cylinder head (3).
INSPECTION
1.
Ensure piston domes, cylinder head, cylinder block deck surfaces, and injector tubes are clean and free of foreign mat-
ter.
2.
Inspect cylinder block bolt holes and block-to-head gasket mating surfaces for oil, water, dirt or old gasket material.
INSTALLATION
1.
Install left rear lifting bracket (23) and secure to cylinder head (3) with bolt (22). Tighten bolt to 75-93 lb-ft (102-126
Nm).
2.
Install new cylinder head gasket (21) on cylinder block (27).
3
21
20
23
26
22
25
24
18
17
19
29
27
28