TB 9-2320-360-13&P-1
A/C KIT INSTALLATION - CONTINUED
0003 00
IN-CAB COMPONENTS - CONTINUED
0003 00
3.
Doghouse Insulation, Mat, and Engine Access Panels Modification.
a.
Tilt rear bench seat cushion up against rear of cab to provide clearance for evaporator housing installation (TM 9-
2320-360-20).
b.
Remove and discard transmission shift cable cover panel located in doghouse from the interior left side of dog-
house (TM 9-2320-360-20).
c.
Remove and discard original doghouse door panel (TM 9-2320-360-20).
d.
Remove doghouse floor mat (TM 9-2320-360-20).
e.
Remove doghouse floor engine access panel from the vehicle (TM 9-2320-360-20).
f.
Remove forward doghouse top insulation, retaining angle, and screws (TM 9-2320-360-20).
g.
Remove rear doghouse top insulation, retaining angle, and screws (TM 9-2320-360-20). Discard screws (to be
replaced by screws during installation).
h.
Remove doghouse top insulation (TM 9-2320-360-20).
i.
Remove doghouse front engine access panel (TM 9-2320-360-20).
j.
Modify doghouse floor engine access panel.
WARN I N G
Always wear gloves and goggles when drilling and grinding. Failure to follow this warning may result in
injury to personnel.
N OTE
When doghouse floor engine access panel is modified, the step portion is removed. This portion is saved and
installed on doghouse after evaporator is installed.
On an armored vehicle the engine access panel does not need to be removed.
(1)
Using template (WP 0057 00), locate and mark six holes (1 and 2) on doghouse floor engine access panel
(3).
(2)
Drill six 1/16-inch diameter pilot holes at locations (1 and 2) marked in previous step.
(3)
Drill two 7/8-inch diameter holes (4) in doghouse floor engine access panel (3) for evaporator drain holes
(5).
(4)
Install two grommets (6), provided with the kit, in two 7/8-inch diameter holes (4) on doghouse floor
engine access panel (3).
(5)
Drill four 25/64-inch diameter holes (7) in doghouse floor engine access panel (3), as noted in template,
for evaporator mounting.
(6)
Install and set four 1/4-20 rivet nuts (8) in 25/64-inch diameter holes (7) (TM 9-2320-360-20).
0003 00-15
