TB 9-2320-360-13&P-1
A/C KIT INSTALLATION - CONTINUED
0003 00
IN-CAB COMPONENTS - CONTINUED
0003 00
4.
Driver and Passenger Side Louvers Installation.
a.
Install driver side louver.
CAU T I ON
The driver side and passenger side louvers are installed in a similar manner. When installing the driver side
louver, be sure to disconnect the shift-lever harness and secure away from the cutting area. Failure to move
the harness out of the cutting area may cause damage to equipment.
(1)
Disconnect shift-lever harness (1) at
connection plug and move ends away
from the cutting area.
449-601
CAU T I ON
Ensure vehicle wheels are chocked before moving transmission selector switch.
N OT E
The driver side and passenger side louvers are installed in a similar manner. Be sure to use driver side tem-
plate, provided with the kit, when installing louver on driver side.
(2)
Move transmission selector switch (2) to "1" position.
(3)
Mark location of driver side outlet louver on left side of doghouse using the driver side metal template (3),
provided with the kit.
(4)
Remove the driver side metal template (3) and connect marks (4) on doghouse to locate the opening to be
cut for driver side louver.
(5)
Using a sharp box-cutter, or similar instrument, cut diagonally from each corner (5) toward centerline (6)
of louver opening approximately 1.50 inches from each end.
(6)
Connect two triangle shapes created by these cuts with a cut from point-to-point.
N OT E
Perforated covering will be used to surround the louver when completely installed.
(7)
Peel back perforated covering (7) from insulating material (8), keeping perforated covering (7) as intact as
possible.
(8)
Remove insulating material (8) beneath perforated covering (7) and discard.
0003 00-19