II106700-7
Rev. -
ak. Attach the four Escape Hatch Brackets (P/N 113357-1) to the top of the cab
adjacent to the Escape Hatch (four sides) using two bolts (3/16 24 x 1/4 LG) and
two washers (3/16 ID) for each bracket.
am. Install the Escape Hatch in the Roof.
an: With the hatch installed, 14 each of the 34 each hatch opening perimeter threaded
holes are not used, and need to be sealed with urethane sealant (P/N 104302).
5.1.10 Re-Install the LH and RH Door-Mounted Outside Mirrors
a. Position the LH outside mirror frame and mirror on the outside of the LH door.
b. Apply Loctite 242 to four bolts (1/4 20 x 1.750 LG).
c. Attach the mirror frame to the door using the four prepared bolts
(1/4 20 x 1.750 LG), four flat washers (1/4 ID), and four locknuts (1/4 20).
d. Torque the locknuts to 9 ft-lb.
e. Repeat Steps "a" through "d" for the RH Door-Mounted Outside Mirror.
5.1.11 Re-install the Blackout Light
a. Remove the Blackout Light from the old bracket and install it in the new bracket,
(P/N 111459-1), using the same hardware (see Figure 46).
b. Extend the vehicle Blackout Light wiring connection using the Pigtail Harness,
(P/N 111438-3) supplied in the Front Armor Protection Kit, P/N 106705-3.
c. Re-connect the vehicle Blackout Light wire connection using the Pigtail Harness,
(P/N 111438-3)
5.1.12 Re-Install the Bridge Weight Sign
a. Re-install the Bridge Weight Sign over the holes provided on the passenger side of
the Upper Brush Guard Cover (P/N 111437-1) and secure it in place using two bolts
(1/4 20 x 1.250 LG), four flat washers (1/4 ID), and two locknuts (1/4 20) (See
b. Torque the two locknuts to 9 ft-lb.
5.1.13 Re-install the Tow Shackles
a. Position one of the tow shackles over one of the frame ends in the front of the
vehicle.
b. Install the retaining pin attaching the tow shackle to the frame end.
c. Install the cotter pin in the retaining pin and spread the cotter pin ends to hold it in
place.
d. Repeat Steps "a" through "c" for the remaining tow shackle.