II106700-7
Rev. -
af. Install four Draw Latch T-Handles (P/N F7-51) onto the bottom of the Escape Hatch
Panel (P/N 113346-1) using two bolts (3/16 24 x 0.750 LG), two metal washers
(3/16 ID), and two rubber washers (0.17 ID, 3/8 OD) for each latch (see Figure 44).
ag. Assemble four Keeper Pins (from the Draw Latch) into the four Escape Hatch
Brackets (P/N 113357-1) with a bolt (3/16 24 x 1/4 LG) and a washer (3/16 ID) for
each bracket.
CAUTION
Do not over-tighten the fasteners. The fasteners will strip the threaded hole in
the Draw Latch Component if they are over-tightened.
ah. Install the four Bracket Assemblies using the hardware shown, and in the locations
shown, in Figure 45. Do not fully tighten the bolts at this time.
Figure 45. Installation of the Escape Hatch Brackets.