II106700-7
Rev. -
Figure 25. Left-hand Headlight Bracket Installed.
c. Install the RH headlight bracket (P/N 111418-2) using three bolts (3/8 16 x 1.500 LG),
six washers (3/8 ID), and three locknuts (3/8 16) (See Figure 25). Hand-tighten the
locknuts. For the bottom holes, use the three bolts (3/8 16 x 1.500 LG),
six washers (3/8 ID), and three locknuts (3/8 16).
d. Install the LH and RH Marker Light Adapter (P/N 111442-1) to the rear of the
Headlight Brackets using five bolts (1/4 20 x 1.000 LG) and five washers
(1/4 ID) for each bracket.
e. Plug the LH and RH headlights and marker lights into the Wiring Extension Harness,
matching the wire colors and cable numbers.
f. Re-install the LH and RH headlights and marker lights in the LH and RH mounting
brackets using the previously saved bolts/washers/nuts
5.1.4 Install the Armored Louvered Grille
NOTE
The Louvered Grille Brackets are marked "THIS SIDE TOWARD RADIATOR" and
"THIS END UP" for proper installation. Verify that the Louvered Grille Brackets
are oriented correctly prior to final assembly.
