II106700-7
Rev. -
Figure 24. Front HEMTT Armor Kit locations.
g. Install the Upper Brush Guard Shim (P/N 106759-1) over the Installation Guides.
h. Feed the LH and RH Wiring Extension Harness through the hole in the Lower Brush
Guard.
k. Using a lift sling and material handling equipment (hoist, forklift, etc.), position the
Upper Brush Guard (P/N 111407-1) onto the Installation Guides, over the installed
Shim, and over the Lower Brush Guard with the "up" arrow (↑) facing the installer.
NOTE
The first and second bolt holes and the sixth and seventh bolt holes from the
passenger-side end of the Upper Brush Guard use two bolts (3/8 - 16 x 4.500 LG),
four washers (3/8 ID), and two nuts (3/8 - 16) for proper installation. Hand-tighten
the bolts. (See Paragraph 5.1.6 if the vehicle is equipped with a gun ring mount.)
At this time, do not install bolts into the bolt holes over the headlight cutouts on
the Upper Brush Guard.
m. Apply Loctite 242 to five bolts (3/8 16 x 1.500 LG).