II106700-5
Rev. B
5.1.11 Re-Install the LH and RH Door-Mounted Outside Mirrors
a. Position the LH outside mirror frame and mirror on the outside of the LH door.
b. Apply Loctite 242 to four bolts (1/4 20 x 1.750 LG).
c. Attach the mirror frame to the door using the four prepared bolts
(1/4 20 x 1.750 LG), four flat washers (1/4 ID), and four locknuts (1/4 20).
d. Torque the locknuts to 9 ft-lb.
e. Repeat Steps "a" through "d" for the RH Door-Mounted Outside Mirror.
5.1.12 Re-Install the Cab Steps (with the Internal Clearance Light)
a. Apply Loctite 242 to four bolts (5/16 18 x 1.250 LG).
b. Position the hard metal cab step onto the bottom surface of the driver's-side Blast
Deflector using the four previously prepared bolts (5/16 18 x 1.500 LG),
eight washers (5/16 ID), and four locknuts (5/16 18). Torque the locknuts to
18 ft-lb.
c. Plug the wiring harness into the Clearance Light. Use the extra Pigtail Harness (P/N
111438-3) supplied in the Side Armor Panel Kit, P/N 103703-9, -10.
d.
Repeat Steps "a" through "c" for the passenger-side cab step.
5.1.13 Re-install the Blackout Light
a. Remove the Blackout Light from the old bracket and install it in the new bracket,
(P/N 111459-1), using the same hardware (see Figure 48B).
b. Extend the vehicle Blackout Light wiring connection using the Pigtail Harness,
(P/N 111438-3) supplied in the Front Armor Protection Kit, P/N 106705-3.
c. Re-connect the vehicle Blackout Light wire connection using the Pigtail Harness,
(P/N 111438-3)
5.1.14 Re-Install the Bridge Weight Sign
a. Re-install the Bridge Weight Sign over the holes provided on the passenger side of
the Upper Brush Guard Cover (P/N 111437-1) and secure it in place using two bolts
(1/4 20 x 1.250 LG), four flat washers (1/4 ID), and two locknuts (1/4 20) (See
d. Torque the two locknuts to 9 ft-lb.