II106700-5
Rev. B
Page 74
Figure 46. Lift the Roof Armor Panel into place on the HEMTT roof.
f. Align the 12 holes in the Roof Armor Panel with the holes in the right-hand side of the
roof top.
g. Remove the lift straps from the material handling equipment and remove the lift
straps from the Roof Armor Panel.
h. Apply Loctite 242 to 10 bolts (5/16 18 x 1.250 LG) and 2 bolts
(5/16 18 x 1.750 LG).
k. Install two bolts (5/16 18 x 1.750 LG), two lockwashers (5/16), two flat washers
(5/16 ID), and two spacers through the two holes located on opposite diagonal
corners of the Roof Armor Panel hatch opening. These bolts serve as pilot guides
for the alignment of the Escape Hatch Cover.
m. Install the 10 bolts (5/16 18 x 1.250 LG), 10 lockwashers (5/16 ID), and
10 flat washers (5/16 ID) through the 10 holes in the passenger side of the Roof
Armor Panel. Hand-tighten the bolts.
NOTE
Use shims (P/N 106796) on the mounts between the Rear Cab Armor Panel and the
Roof Armor Panel Rear Bracket (P/N 106736-1) (See Figure 43).
