II106700-5
Rev. B
Page 49
Figure 30. Install Mounting Armor Brackets to the driver's-side rear cab armor panel.
d. Apply Loctite 242 to 12 bolts (1/4 - 20 x 0.750 LG) and install them two turns into the
four Mounting Armor Brackets (P/N 106734-4) previously installed on the driver's-
side rear cab armor panel.
d1. Using a bolt (3/8 16 x 1.250), washer (3/8 ID), and the nut eye (P/N 106795),
secure the nut eye in the 1/2-in. hole in the center of the panel with the nut eye
outboard. Once the panel is secured, remove the nut eye and replace it with a
washer (3/8 ID) and lock nut (3/8 16) from the Extra Fastener Kit. Torque to
35 ft-lb. The nut eye will be used to position the other rear cab armor panel.
e. Using a lift sling and material handling equipment (hoist, forklift, etc.) position the
driver's-side Rear Cab Armor Panel (P/N 106724-3) onto the outside rear of the cab,
with the arrow (↑) pointing up and facing the installer, and slide the Mounting Armor
Brackets over the rear cab window opening edges (See Figure 31).