TM 9-2320-363-34-2
C A U T I O N
Do not separate bearing components. Bearing assembly is a matched set of
parts and should be installed as received. Failure to do so could result in
bearing misalinement and/or foreign material in bearings.
1.
PLACE SERVICE SET HOLDING FIXTURE (1) ON PRESS BED. INSTALL DRIVE SHAFT SUPPORT
TOOL (2) IN HOLDING FIXTURE (1). INSTALL SQUARE END OF WATER PUMP SHAFT (3) IN
SUPPORT TOOL (2).
NOTE
Make sure roller bearing identification numbers are against bearing and seal
installer.
2.
POSITION NEW ROLLER BEARING (4) ON WATER PUMP SHAFT (3) WITH ROLLER BEARING
IDENTIFICATION NUMBERS UP. USING SMALL END OF SERVICE SET BEARING AND SEAL
INSTALLER (5), PRESS ROLLER BEARING (4) ON WATER PUMP SHAFT (3) UNTIL ROLLER
BEARING IS SEATED AGAINST SHOULDER OF WATER PUMP SHAFT. REMOVE ASSEMBLED
SHAFT AND BEARING FROM HOLDING FIXTURE.
12-195
