TM 9-2320-363-34-2
5.
APPLY THIN FILM OF CLEAN ENGINE LUBRICATING OIL TO SEALING LIP OF OIL SEAL.
LUBRICATE ROLLER BEARING ASSEMBLY (9). INSTALL SQUARE END OF WATER PUMP SHAFT
(3) CAREFULLY THRU OIL SEAL AND POSITION ROLLER BEARING ASSEMBLY (9) IN WATER
PUMP HOUSING BORE (7).
6.
USING LARGE END OF SERVICE SET BEARING AND SEAL INSTALLER (5), PRESS ROLLER
BEARING AND SHAFT ASSEMBLY IN WATER PUMP HOUSING BORE (7) UNTIL ROLLER
BEARING (9) IS SEATED AGAINST SHOULDER OF WATER PUMP HOUSING BORE. REMOVE
BEARING INSTALLER.
NOTE
Make sure retaining ring is fully seated in ring groove.
7.
INSTALL RETAINING RING (10) IN RING GROOVE (11) OF WATER PUMP HOUSING BORE (7).
12-197
