TM 9-2320-363-34-2
Whenever water pump shaft is removed, discard roller bearing.
7.
WITH SQUARE END OF WATER PUMP SHAFT (7) DOWN, SUPPORT WATER PUMP SHAFT
ROLLER BEARING (16) ON INNER RACE OF ROLLER BEARING. PRESS WATER PUMP SHAFT (7)
FROM ROLLER BEARING (16). DISCARD ROLLER BEARING.
C A U T I O N
Be careful when removing oil seal to prevent damage to water pump housing
seal bores.
NOTE
Whenever water pump shaft is removed, discard oil seal.
8.
PLACE WATER PUMP HOUSING (6) ON BENCH, IMPELLER SIDE DOWN. USING BRASS DRIFT
AND HAMMER, REMOVE WATER SEAL (17) FROM WATER PUMP HOUSING (6) BORE. DISCARD
WATER SEAL.
12-193
