TM 9-2320-302-34
0089 00-18
STEERING GEAR REPAIR - CONTINUED
0089 00
ASSEMBLY - CONTINUED
NOTE
If adjusting screw was removed, perform steps 33 through 36.
33.
Place sector shaft (3) in soft-jawed vise, apply a light coat of grease to new adjusting screw (11), and install adjusting
screw and new retainer (15).
34.
Tighten adjusting screw (11) so that end play is 0-0.002 in (0-0.05 mm) but adjusting screw can still be turned by hand.
Check end play by hand with dial indicator.
35.
Stake retainer (15) into two slots in sector shaft (3).
36.
Ensure adjusting screw (11) can still be turned by hand and end play is still 0-0.002 in (0-0.05 mm). If not, repeat disas-
sembly step 13 and installation steps 32 through 35.
37.
Apply a light coat of lubricating oil to bushing in side cover (9) and new seal (13). Install seal on installation end of
bearing inserter with spring side toward shoulder of tool.
38.
Install seal (13) in side cover (9).
11
15
3
13
9
