TM 9-2320-302-34
0089 00-20
STEERING GEAR REPAIR - CONTINUED
0089 00
ASSEMBLY - CONTINUED
42.
Replace masking tape on sector shaft (3) with one layer of new masking tape.
43.
Install new gasket (10), sector shaft (3), and side cover (9) as an assembly in housing (4). Center tooth of sector shaft (3)
must be in valley between second and third tooth of rack piston (22).
44.
Apply a light coat of lubricating oil to six screws (8). Install screws in housing (4) and tighten to 160-180 lb-ft (217-244
Nm) in sequence shown.
45.
Pack trunnion area of sector shaft (3) with grease. Apply a light coat of grease to new seal (5) and install seal in sector
shaft.
46.
Apply a light coat of grease to new seal (19). Using small end of input seal installer, tap seal into valve housing (20)
until shoulder of input seal installer rests against valve housing. Clean off any seal material that may have shredded off.
47.
Install new retaining ring (44) and pack end of valve housing (20) with grease.
48.
Apply a light coat of grease to new seal (45) and install seal in valve housing (20).
4
22
9
10
3
8
3
5
