TM 9-2320-302-34
0089 00-14
STEERING GEAR REPAIR - CONTINUED
0089 00
ASSEMBLY - CONTINUED
16.
Reverse valve housing (20) in vise.
17.
Apply a light coat of lubricating oil to new adjuster lock nut (32).
18.
Using spanner wrenches (34 and 35), install adjuster lock nut (32) while holding adjuster (33) in place. Tighten adjuster
lock nut to 101-122 lb-ft (137-165 Nm). Check torque reading noted in step 14. If torque reading is not within 5-10 lb-in
(0.56-1.13 Nm) higher, remove adjuster lock nut, back off adjuster ½ turn, and repeat steps 13 through 18.
19.
Stake valve housing (20) in clockwise-most corner of two opposing slots of adjuster lock nut (32). Stake adjuster lock
nut on adjuster (33) in one place at threaded area. Check torque reading on input shaft (2). Reading must not exceed 22
lb-in (2.5 Nm).
20.
Apply a light coat of lubricating oil to two new packings (23 and 24) and install packings in valve housing (20).
21.
Apply a light coat of lubricating oil to new packing (31) and new seal ring (30). Install packing and seal ring on rack pis-
ton (22).
35
32,33
34
20
20
24
23
2
32
33
