TM 9-2320-302-34
0089 00-13
STEERING GEAR REPAIR - CONTINUED
0089 00
ASSEMBLY - CONTINUED
13.
Reverse valve housing (20) in vise.
14.
Using 19 mm deep well socket, rotate input shaft (2). Note amount of torque required to rotate input shaft in each direc-
tion.
15.
Using spanner wrench (35), tighter adjuster (33) so that torque reading on input shaft (2) is 5-10 lb-in (0.56-1.13 Nm)
higher than noted in step 14. Maximum torque required to rotate input shaft must not exceed 22 lb-in (2.5 Nm).
35
20
33
35
20
2
33
