TM 9-2320-302-34
0071 00-57
TRANSMISSION OVERHAUL - CONTINUED
0071 00
ASSEMBLY - CONTINUED
Installation of Control Valve Module
1.
Position transmission in a vertical position, torque converter up.
2.
Install two guide pins in two main housing bolt holes. Install new control module gasket (33) over guide pins.
3.
Lubricate wiring harness feed-through hole with petrolatum.
4.
With assistance, guide control module (32) onto main housing (23) and pass feed-through harness (27) through feed-
through hole in the main housing.
5.
Align control module (32) bolt holes with guide pins. Ensure feed-through harness standoff is aligned with hole in main
housing (23).
6.
Lower control module (32) over guide pins until it seats against main housing (23) and feed-through harness standoff
seats against tapered hole in main housing.
7.
Remove guide pins and install 43 bolts (31). Evenly tighten bolts to 38-45 lb-ft (51-61 Nm).
8.
Install retaining nut (25) and lock washer (26) to secure feed-through harness (27) to mounting bracket (28).
9.
Install retaining nut (29) and lock washer (30) to secure feed-through harness (27) to transmission housing (23).
33
23
32
31
28
25,26
27
29,30
27
