TM 9-2320-302-34
0071 00-56
TRANSMISSION OVERHAUL - CONTINUED
0071 00
ASSEMBLY - CONTINUED
Installation of Torque Converter Module and Selective Shim Measurement - Continued
5.
Use dimension C and Table 1, Torque Converter Selective Shims, located at the end of this work package, to determine
proper selective shim part number.
6.
Remove torque converter end play tool (J37548).
7.
Install selective shim (20) with step side down, toward turbine shaft. Install converter center bolt (19) with converter
tightening tool (J38564) and retaining ring (13).
NOTE
Turbine and turbine shaft may rotate while attempting to tighten retaining bolt. Prevent turbine shaft from
turning in same manner as in step number 3.
8.
Tighten converter center bolt (19) to 74-88 lb-ft (100-120 Nm). Remove retaining ring (13) and tool (J38564) and
replace with converter plug (14), o-ring (15), and retaining ring (13).
9.
Install torque converter shipping bracket. Tighten shipping bracket mounting bolts to 38-45 lb-ft (51-61 Nm).
20
19
15
14
13
18
21
18
21
CUPPED END DOWN
J38564
17
16
