TM 9-2320-302-34
0071 00-62
TRANSMISSION OVERHAUL - CONTINUED
0071 00
Table 2. Wear Limits Data - Continued.
DESCRIPTION
WEAR LIMIT
MM
INCHES
MAIN HOUSING MODULE - CONTINUED
P1 Ring Gear Spline, Maximum Wear
0.38
0.015
C3, C4, C5 Friction Plate, Maximum Cone
0.25
0.010
C3, C4, C5 Friction Plate, Minimum Thickness
3.485
0.137
C3, C4, C5 Reaction (Steel) Plate, Maximum Cone
0.25
0.010
C3, C4, C5 Reaction (Steel) Plate, Minimum Thickness
2.41
0.095
C3, C4, Clutch Housings, Maximum Spline Wear
1.15
0.045
Main Housing, Maximum Spline Wear
1.15
0.045
MAIN SHAFT MODULE - WIDE RATIO AND CLOSE RATIO
Main Shaft Bearing Journal, Minimum OD
52.98
2.086
Main Shaft Pilots (Both Ends), Minimum OD
35.92
1.414
P1 PLANETARY MODULE
P1 Planetary Carrier Assembly, Maximum Pinion End Play
0.94
0.037
P1 Carrier Bushing, Maximum ID
89.32
3.517
P1 Pinion Thrust Washer, Minimum Thickness
1.40
0.055
P1 Pinion Trust Washer, Maximum Step Wear
0.12
0.005
P2 Ring Gear Spline, Maximum Wear
0.38
0.015
P2 PLANETARY MODULE
P2 Planetary Carrier Assembly, Maximum Pinion End Play
0.94
0.037
P2 Carrier Bushing, Maximum ID
53.23
2.096
P2 Pinion Thrust Washer, Minimum Thickness
1.40
0.055
P2 Pinion Thrust Washer, Maximum Step Wear
0.12
0.005
P3 Ring Gear Spline, Maximum Wear
0.38
0.015
REAR COVER AND P3 MODULE
P3 Planetary Carrier Assembly, Maximum End Play
0.94
0.037
Output Shaft Bushing, Maximum ID
36.14
1.423
Output Shaft, Maximum Spline Wear
0.38
0.015
P3 Pinion Thrust Washer, Minimum Thickness
1.40
0.055
P3 Pinion Thrust Washer, Maximum Step Wear
0.12
0.005
OUTPUT FLANGE AND YOKE
Journal Seal, Maximum OD
85.0
3.346