TM 9-2320-302-34
0071 00-59
TRANSMISSION OVERHAUL - CONTINUED
0071 00
ASSEMBLY - CONTINUED
Installation of Output Shaft and Oil Seal
1.
Install new oil seal (12) in rear cover.
2.
Install output yoke (11) and new o-ring (10).
3.
Insert bolt (7) through retainer plug (8). Install a new o-ring (9) on bolt so that o-ring seats against retainer plug.
4.
Install retainer plug (8) into yoke (11). Tighten bolt (7) to 38-45 lb-ft (51-61 Nm).
5.
Install engine, turbine, and output speed sensors (TM 9-2320-302-20).
7
8
9
10
11
12
