TM 9-2320-302-34
0071 00-22
TRANSMISSION OVERHAUL - CONTINUED
0071 00
MODULE OVERHAUL - CONTINUED
Rotating Clutch Module Disassembly
1.
Remove thrust bearing (1) and retaining ring (2) from rotating clutch module (3). Inspect thrust bearing. If worn, dis-
card.
2.
Remove P1 sun gear assembly (4) and thrust bearing (5) from rotating clutch module (3).
3.
Remove C2 retaining ring (6) and backplate (7).
4.
Measure wear surface thickness of C2 backplate (7). Minimum thickness allowed is 0.311 in (7.90 mm). Check flatness
of backplate. Maximum allowable distortion is 0.006 in (0.15 mm).
5.
Remove C2 clutch pack containing seven friction plates (8) and seven steel reaction plates (9). Perform the following
measurements:
a.
Friction plate thickness: minimum thickness allowed is 0.115 in (2.92 mm).
b.
Friction plate oil groove depth: minimum depth allowed is 0.008 in (0.20 mm).
c.
Friction plate cone: maximum cone allowed is 0.010 in (0.25 mm).
23
20
2122
1
18
3
17
19
16
15
14
14
13
8
9
10
12
12
11
2
5
4
6
7
