TM 9-2320-302-34
0071 00-21
TRANSMISSION OVERHAUL - CONTINUED
0071 00
MODULE OVERHAUL - CONTINUED
Front Support and Charging Oil Pump Module Assembly - Continued
9.
Secure pump housing (4) to front support (2) with eight bolts (3). Tighten bolts to 38-45 lb-ft. (51-61 Nm).
NOTE
Butt-joint seal rings require special handling during assembly. Seal rings contain materials that absorb mois-
ture from atmosphere, causing them to expand. Check seal ring end clearance before installation to ensure
seal ring has not expanded.
10.
Measure end gap of three rotating seal rings (1) before installation. Insert seal rings into the rotating clutch hub bore of
front support (2) and measure end gap with a thickness gage. Seal ring end gap must be 0.040-0.057 in (1.00-1.44 mm).
11.
Install three rotating seal rings (1) on front support hub.
RELIEF VALVE
BORE
DOWEL
PINS
E
E
FRONT SUPPORT
DOWEL PIN
GROUND SLEEVE
SPLINE OD T.I.R.
0.13 mm
(0.005 in)
SECTION E-E
BOTTOM
VIEW A
VIEW B
INSTALL
REMOVE
TO INSTALL, ALIGN FLAT ON
GROUND SLEEVE WITH ARROW
ON FRONT SUPPORT
GROUND SLEEVE
VIEW C
14.5 mm
(0.57 in)
