TM 9-2320-302-34
0071 00-25
TRANSMISSION OVERHAUL - CONTINUED
0071 00
MODULE OVERHAUL - CONTINUED
Rotating Clutch Module Disassembly - Continued
17.
Lift rotating drum (31) from clutch hub (18) and C1/C2 pistons (32 and 33). Inspect clutch splines of rotating drum.
Maximum spline wear allowed is 0.015 in (0.38 mm).
18.
Remove C1/C2 pistons (32 and 33) and seal rings (34 and 35) from clutch hub (18), by rocking pistons from side to side.
19.
Inspect and measure ID of rotating clutch hub housing bushing (36). Maximum allowable ID of bushing is 4.735 in
(120.27 mm). Remove bushing from clutch hub (18) if replacement is necessary. Avoid damaging bushing bore.
20.
Remove piston seal rings (37 and 38) from clutch hub (18).
21.
Separate C1 piston (32) and seal ring (35) from C2 piston (33) and seal ring (34) by lightly tapping on C1 piston.
31
36
18
3
37
38
34
33
29
25
24
27
26
32
35
28
30