TM 9-2320-302-34
0071 00-24
TRANSMISSION OVERHAUL - CONTINUED
0071 00
MODULE OVERHAUL - CONTINUED
Rotating Clutch Module Disassembly - Continued
WARNING
The rotating clutch piston springs are highly compressed and must be properly released. Failure to follow
this warning may result in personnel injury
12.
Place rotating clutch (3) on tool base (J37030-3) so rotating drum is supported by tool tangs (View C).
13.
Install tool (J35923-2) with bearing, washer, and handle. Tighten tool, compressing C1 balance piston (24) and C1
spring assembly (25). Remove retaining ring (26) (View A).
14.
Release spring tension by rotating handle in counterclockwise direction. Remove tool (J35923-2) with bearing, washer,
and handle.
15.
Remove C1 balance piston (24), seal ring (27), and C1 spring assembly (25).
16.
Install tools (J37030-3, J37030-1, and J35923), bearing, washer, and handle. Tighten tool and remove retaining ring
(28). Remove tools after relieving spring tension. Remove spring assembly (29) and spring plate (30) (View B).
J37030-3
HANDLE
FLAT WASHER
BEARING
J35923-2
BEARING
FLAT WASHER
HANDLE
J37030-3
J35923-2
J37030-1
ALIGNMENT SLOTS
J37030-3
3
VIEW A
VIEW B
VIEW D
VIEW C
