TM 9-2320-302-34
0023 00-3
CRANKSHAFT REAR OIL SEAL REPLACEMENT - CONTINUED
0023 00
INSTALLATION - CONTINUED
CAUTION
Ensure flywheel housing seal bore, rear of crankshaft, and both sides of oil seal installer base and spacer are
clean, smooth, and free of any foreign material. Failure to do so may cause damage to equipment.
3.
Position seal inserter base (7) on rear of crankshaft (5).
4.
Install two guide studs (8) in two flywheel bolt holes 180 degrees apart.
5.
Hand tighten two guide studs (8) until seal inserter base (7) is tight against rear of crankshaft (5).
6.
Install oil seal (6) onto crankshaft (5) as far as it will go by hand.
7.
Install seal inserter spacer (9) on center screw (10).
8.
Position seal inserter collar (11) on oil seal (6).
9.
Place seal inserter housing (12) over center screw (10) and two guide studs (8). Position seal inserter housing against
seal inserter collar (11) and crankshaft rear oil seal (6).
10.
Install thrust bearing (13) on center screw (10) with lettered side against seal inserter housing (12).
11.
Install nut (14) on center screw (10). Tighten nut until crankshaft rear oil seal (6) is firmly seated.
12.
Remove nut (14), thrust bearing (13), seal inserter housing (12), seal inserter collar (11), spacer (9), guide studs (8), and
seal inserter base (7) from crankshaft (5).
13.
Install flex plate (WP 0025 00).
14.
Install power pack (WP 0010 00).
END OF WORK PACKAGE
5
7
8
6
9
11
12
13
14
10
