TM 9-2320-302-34
0024 00-3
FLYWHEEL HOUSING REPLACEMENT - CONTINUED
0024 00
INSTALLATION
1.
Apply continuous thin bead of gasket forming compound to rear face of cylinder block (7) where it contacts flywheel
housing (3).
2.
Install two guide studs (4) on cylinder block (7).
3.
Position flywheel housing (3) carefully on guide studs (4), working it forward until flywheel housing contacts cylinder
block (7).
4.
Install eight washers (6) and bolts (5), and two washers (2) and bolts (1) hand tight.
5.
Remove guide studs (4) and install two remaining washers (2) and bolts (1) hand tight.
6.
Tighten 12 bolts (1 and 5) to 118-148 lb-ft (160-201 Nm), in sequence shown.
7.
Install crankshaft rear oil seal (WP 0023 00).
8.
Install flex plate (WP 0025 00).
10
1
2
3
4
5
6
7
8
9
11
12
TIGHTENING SEQUENCE
