TM 9-2320-302-20
0130 00-3
DRIVELINE U-JOINTS AND BEARINGS REPLACEMENT - CONTINUED
0130 00
INTER-AXLE DRIVELINE U-JOINTS REMOVAL - CONTINUED
3.
Remove two grease fittings (22) from universal joint (19).
NOTE
Note matchmarks on each half of inter-axle driveline for installation. Scribe or paint matchmarks on drive-
line if matchmarks are missing.
4.
Remove dust seal (23) and yoke (20) from inter-axle driveline (21).
5.
Remove grease fitting (24) from yoke (20).
NOTE
Perform the following steps at rear end of inter-axle driveline.
6.
Remove two screws (25) from each of two bearing caps (26). Discard screws.
7.
Remove two bearing caps (26) and universal joint (27) from inter-axle driveline (21).
8.
Remove two grease fittings (28) from universal joint (27).
MAIN DRIVELINE U-JOINTS INSTALLATION
NOTE
Perform the following steps at rear end of main driveline.
1.
Install two grease fittings (16) on universal joint (13).
2.
Position universal joint (13) and two bearing caps (15) to main driveline (7).
28
27
25
26
21
23
20
24
17
18
19
22
