TM 9-2320-302-20
0130 00-5
DRIVELINE U-JOINTS AND BEARINGS REPLACEMENT - CONTINUED
0130 00
INTER-AXLE DRIVELINE U-JOINTS INSTALLATION
NOTE
Perform the following steps at rear end of inter-axle driveline.
1.
Install two grease fittings (28) on universal joint (27).
2.
Position universal joint (27) and two bearing caps (26) on inter-axle driveline (21).
3.
Install two new screws (25) on each of two bearings caps (26). Tighten screws to 36 lb-ft (49 Nm).
4.
Lubricate universal joint (27) (WP 0021 00).
5.
Install grease fitting (24) on yoke (20).
NOTE
Align matchmarks on each half of inter-axle driveline.
6.
Install dust seal (23) and yoke (20) on inter-axle driveline (21). Tighten dust seal.
NOTE
Perform the following steps at front end of inter-axle driveline.
7.
Install two grease fittings (22) to universal joint (19).
8.
Position universal joint (19) and two bearing caps (18) on yoke (20) of inter-axle driveline (21).
9.
Install two new screws (17) on each of two bearing caps (18). Tighten screws to 36 lb-ft (19 Nm).
10.
Lubricate yoke (20) and universal joint (19) (WP 0021 00).
11.
Install inter-axle driveline (WP 0129 00).
END OF WORK PACKAGE
28
27
25
26
21
23
20
24
17
18
19
22