TM 9-2320-302-20
0056 00-2
STARTER REPLACEMENT - CONTINUED
0056 00
INSTALLATION
1.
While supporting starter (10), install starter on engine flywheel housing (20) with three screws (19). Do not fully tighten
screws.
NOTE
For aluminum flywheel housings, tighten screws to 138-154 lb-ft (187-209 Nm). For cast iron flywheel
housings, tighten screws to 181-226 lb-ft (245-306 Nm).
2.
Tighten three screws (19).
3.
Install two wires (18), ground strap (17), cable (16), washer (15), and nut (14) on starter (10). Tighten nut to 20-25 lb-ft
(27-34 Nm).
4.
Install wire (13), washer (12), and nut (11) on starter (10). Tighten nut to 16-30 lb-ft (1.8-3.4 Nm).
5.
Install three wires (9), cable (8), washer (7), and nut (6) on starter (10). Tighten nut to 16-30 lb-ft (1.8-3.4 Nm).
6.
Install wire (4), cable (3), washer (2), and nut (1) on threaded stud (5). Tighten nut to 16-30 lb-ft (1.8-3.4 Nm).
END OF WORK PACKAGE
3
4
1
10
19
15
16
14
18
20
2
5
17
9
8
7
6
13
12
11
