TM 9-2320-302-20
0054 00-2
ALTERNATOR BELT REPLACEMENT AND ADJUSTMENT - CONTINUED
0054 00
INSTALLATION
1.
Position drive belt (9) on alternator pulley (10), air conditioning compressor pulley (11), and accessory drive pulley
(12).
2.
Install cap screw (3) if removed. If not, proceed to step 3.
3.
Tighten drive belt tension by loosening hex nut (8) and tightening hex nut (7) on adjusting rod (6) and link (5) until drive
belt is tight. Tighten hex nut (8).
4.
Tighten three cap screws (2, 3, and 4) to 60-70 ft-lb (81-95 Nm).
ADJUSTMENT
1.
Back off hex nut (8) and tighten hex nut (7) until belt tension measures 90-100 lb (400 N) on tensiometer (13).
2.
Start engine (TM 9-2320-302-10) and operate engine for 30 minutes (or 15 miles).
3.
Check belt tension and adjust as required to maintain 80-100 lb-ft (36-45 Nm). Recheck belt tension again after 8 hours
of operation and adjust as required.
END OF WORK PACKAGE
13
8
3
5
7
6
4
11
9
12
2
1
10
