TM 9-2320-302-20
0052 00-3
WATER PUMP MAINTENANCE - CONTINUED
0052 00
WATER PUMP SEAL INSTALLATION - CONTINUED
WARNING
Size and tension of snap ring could cause injury to personnel if snap ring slips off snap ring pliers. Wear face
shield when installing water pump cover snap ring.
3.
Install water pump cover snap ring (17) in groove of water pump (3). Tap around inside rim of snap ring to fully seat in
groove of water pump.
WATER PUMP INSTALLATION
1.
Apply a light coat of clean lubricating oil to new gasket (16). Install gasket in groove on water pump (3).
2.
Position water pump (3) on gear housing (15), meshing water pump gear with gear train. Install water pump with two
long bolts (13) and short bolt (14). Tighten bolts to 43-54 lb-ft (58-73 Nm).
3.
Install drain valve (12) on water pump (3).
4.
Install two bushings (11), adapter (10), and two elbows (9) on water pump (3).
5.
Position two hose clamps (6), heater hose (8), and water filter hose (7) on two elbows (9). Tighten hose clamps.
6.
Position two hose clamps (4) and water bypass hose (5) on water pump (3). Tighten hose clamps.
7.
Position two hose clamps (1) and oil coo1er hose (2) on back of water pump (3). Tighten hose clamps.
8.
Install oil level dipstick (WP 0023 00).
9.
Install radiator-to-water pump coolant line (WP 0042 00).
10.
Fill cooling system (WP 0041 00).
11.
Operate vehicle (TM 9-2320-302-10) and check for coolant leaks.
END OF WORK PACKAGE
