TM 9-2320-302-20
0027 00-1
AIR COMPRESSOR DISCHARGE HOSE REPLACEMENT
0027 00
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Tools and Special Tools
Tool kit, general mechanics (Item 36, WP 0236 00)
Materials/Parts
Nut, lock (P/N MS51922-1)
References
TM 9-2320-302-10
Equipment Condition
Air system drained (TM 9-2320-302-10)
Transmission tunnel access cover removed (WP
0207 00)
REMOVAL
1.
Remove discharge hose (1) from air compressor elbow fitting (2).
2.
Remove lock nut (3), screw (4), washer (5), and clamp (6) from mounting bracket (7). Discard lock nut.
3.
Remove screw (8), washer (9), and mounting bracket (7) from engine block (10).
4.
Remove nut (11), washer (12), and two hose clamps (13) and (14) from standoff bracket (15)
5.
Reinstall hose clamp (13) on standoff bracket (15) with washer (12) and nut (11).
NOTE
Discharge hose from compressor to air dryer is routed in a continuous downward slope to prevent collection
of moisture in line. Hose clamps, secured to standoff mounting brackets at 12-20 in (30-51 cm) intervals, are
used to secure compressor discharge hose and other hoses in place. Replace damaged standoff bracket as
required.
6.
Remove discharge hose (1) and inline fitting (16) from air dryer hose (17).
2
1
4
5
6
7
3
8
9
10
11
12
13
14
15
16
17
1