TM 5-2330-325-14&P
4-48.
SLACK ADJUSTER REPLACEMENT (Continued).
b.
Cleaning.
(1)
Remove surface dirt with water and brush.
WARNING
Solvents can burn easily, can give off harmful vapors, and are harmful to skin and
clothing. To avoid injury or death, keep away from open fire and use in a well-
ventilated area. If solvent gets on skin or clothing, wash immediately with soap
and water.
(2)
Remove grease and oil with cleaning compound. Dry thoroughly.
(3)
Lubricate in accordance with Appendix I, Lubrication Instructions.
c.
Inspection.
(1)
Inspect for damage and condition of splines. Replace defective or missing parts.
(2)
Inspect for rust or corrosion.
d.
Installation.
(1)
Set 15/16 in. jamnut (1) 2-5/8 in. (13.34 cm) from air chamber.
(2)
Slide 1-1/4 in. slack adjuster nut (2) onto air chamber shaft until it makes contact jamnut
(1).
(3)
Install slack adjuster (8) onto camshaft (7).
(4)
Install flat washer (5) and snap ring (6).
NOTE
Turn adjusting screw (4) clockwise to align clevis (3) and air chamber
shaft (9).
4-53
