M1070 HET ARMOR KIT
II113400
Rev. D
3.
Install seat belt assemblies as follows (see Figure 3-14):
a. Re-install four upper seat belt assemblies and lower seat belt retractors through rear armor and cab using
one bolt (2), one flat washer (3), one spacer (1), and one locknut (4) for each assembly. (Use original flat
washers on the inside of vehicle.). Torque to 7 lb-ft.
NOTE
Ensure dowel on lower seat bolt retractors is aligned properly with slot (hole) in cab.
INSTALLATION 3-24
JUNE 2005