M1070 HET ARMOR KIT
II113400
Rev. D
a. Installation
1. Pre-assemble rear panel as follows (see Figure 3-12):
a. Install three rear panel brackets (1) and three stud plates (2) onto rear panel (3) and secure each with four
flat washers (4) and locknuts (5). Tighten. However, allow bracket to slide freely from side to side.
b. Install seven 90-degree joiner brackets (6) onto rear panel (3) and secure each with three flat washers (7)
and locknuts (8). Do not tighten locknuts at this point.
NOTE
Joiner brackets may be installed just after the rear panel is hung on the roof studs in the next step.
c. Install two rear light brackets (9) onto rear panel (3) and secure each with four screws (10), eight flat
washers (11), and four locknuts (12).
d. Install two lift brackets (13) onto rear panel (3) and secure each with one bolt (14), flat washer (4), and
locknut (5). Torque locknut to 35 lb-ft.
e. Install each MTS antenna mount bracket (7 and 8) onto rear panel (3) and secure each with
locknuts (5). Torque nuts to 23 lb-ft.
INSTALLATION 3-20
JUNE 2005