M1070 HET ARMOR KIT
II113400
Rev. D
2.
Install rear panel as follows (see Figure 3-13):
NOTE
Repositioning of 90-degree joiner brackets may be required to provide adequate
clearance while mounting the rear panel assembly.
a. Install trim-seal (1) around perimeter of rear window opening on vehicle. (Approx. 10 ft.)
b. Using appropriate lifting device, hardware, and personnel, lift rear panel assembly into place onto cab.
c. As rear panel assembly drops into position, align top slot rows of all rear panel brackets onto back row of
∅3/8-inch studs on the roof.
NOTE
Some adjustment is allowed to the left and right in the three rear panel brackets,
if required. 90-deg joiner brackets may be inserted, as shown in Figure 3-12, if
not previously installed.
d. Verify that all holes in rear panel assembly are aligned with features on cab and that appropriate fasteners
and spacers will assemble properly.
e. Install 12 flat washers (2) and locknuts (3) onto studs on roof panel. Do not torque locknuts at this time.
INSTALLATION 3-22
JUNE 2005