II106700-7
Rev. -
3/4 x 10 Large Holes
Small Holes
Figure 32. Secure the Center Blast Deflector to the Mounting Bracket.
10. Torque the eight locknuts (3/4 10) to 280 ft-lb.
11. Install three bolts (3/8 - 16 x 1.500 LG), six flat washers (3/8 in. ID, USS 1 in. OD)
and three locknuts (3/8 16) through the smaller bolt holes in the forward edge of
the driver's-side Blast Deflector. Repeat the operation for the passenger-side
Blast Deflector (see Figure 32). Hand-tighten the locknuts.
12. Torque the three locknuts (3/8 16) to 35 ft-lb, the three locknuts (3/4 10) on
the forward edge of the driver's-side Blast Deflector to 280 ft-lb, and the
eight bolts (1/2 13 x 1.500 LG) over the driver's-side rear fender support to
80 ft-lb.
13. Torque the three locknuts (3/8 16) to 35 ft-lb, the three locknuts (3/4 10) on
the forward edge of the passenger-side Blast Deflector to 280 ft-lb, and the
eight bolts (1/2 13 x 1.500 LG) over the passenger-side rear fender support to
80 ft-lb.
14. Spread the slot in the pitman arm (see Item 1 in Figure 33) and install one end of
the drag link (2) into the pitman arm.
15. Install the screw (3), lockwasher (4), and nut (5) through the pitman arm and
torque it to 70-80 ft-lb.